设为首页 | 加入收藏
YANG Chan-Su,KIM Sun-Hwa,OUCHI Kazuo,BACK Ji-Hun.Generation of high resolution sea surface temperature using multi-satellite data for operational oceanography[J].Acta Oceanologica Sinica,2015,34(7):74-88
Generation of high resolution sea surface temperature using multi-satellite data for operational oceanography
投稿时间:2014-06-04  修订日期:2015-01-12
DOI:10.1007/s13131-015-0694-8
中文关键词:  
英文关键词:SST  satellite  in-situ  high resolution  OI
基金项目:
作者单位E-mail
YANG Chan-Su Korea Ocean Satellite Center, Korea Institute of Ocean Science & Technology (KIOST), Ansan 426-744, Korea
Ocean Science and Technology School, Korea Maritime and Ocean University, Busan 606-791, Korea
Marine Environmental System Science, Korea University of Science and Technology, Daejeon 305-350, Korea 
 
KIM Sun-Hwa Korea Ocean Satellite Center, Korea Institute of Ocean Science & Technology (KIOST), Ansan 426-744, Korea scorpio96@kiost.ac.kr 
OUCHI Kazuo Korea Ocean Satellite Center, Korea Institute of Ocean Science & Technology (KIOST), Ansan 426-744, Korea  
BACK Ji-Hun Korea Ocean Satellite Center, Korea Institute of Ocean Science & Technology (KIOST), Ansan 426-744, Korea  
摘要点击次数: 2019
全文下载次数: 2141
中文摘要:
      
英文摘要:
      In the present article, we introduce a high resolution sea surface temperature (SST) product generated daily by Korea Institute of Ocean Science and Technology (KIOST). The SST product is comprised of four sets of data including eight-hour and daily average SST data of 1 km resolution, and is based on the four infrared (IR) satellite SST data acquired by advanced very high resolution radiometer (AVHRR), Moderate Resolution Imaging Spectroradiometer (MODIS), Multifunctional Transport Satellites-2 (MTSAT-2) Imager and Meteorological Imager (MI), two microwave radiometer SSTs acquired by Advanced Microwave Scanning Radiometer 2 (AMSR2), and WindSAT with in-situ temperature data. These input satellite and in-situ SST data are merged by using the optimal interpolation (OI) algorithm. The root-mean-square-errors (RMSEs) of satellite and in-situ data are used as a weighting value in the OI algorithm. As a pilot product, four SST data sets were generated daily from January to December 2013. In the comparison between the SSTs measured by moored buoys and the daily mean KIOST SSTs, the estimated RMSE was 0.71℃ and the bias value was -0.08℃. The largest RMSE and bias were 0.86 and -0.26℃ respectively, observed at a buoy site in the boundary region of warm and cold waters with increased physical variability in the Sea of Japan/East Sea. Other site near the coasts shows a lower RMSE value of 0.60℃ than those at the open waters. To investigate the spatial distributions of SST, the Group for High Resolution Sea Surface Temperature (GHRSST) product was used in the comparison of temperature gradients, and it was shown that the KIOST SST product represents well the water mass structures around the Korean Peninsula. The KIOST SST product generated from both satellite and buoy data is expected to make substantial contribution to the Korea Operational Oceanographic System (KOOS) as an input parameter for data assimilation.
查看全文   查看/发表评论  下载PDF阅读器
关闭